New Security Guard Shack/Guard House/Guard Booth with Sliding Door

Description

This is a Brand New Guard Shack, Guard House, Guard Booth or Security Booth. The Booth is constructed with all aluminum with exception to the Steel Base Frame. This is the only Booth on ebay with a Sliding Door. The specifications are as follows;
4' x 6' STANDARD
ALUMINUM
BUILDING:
A.
General
: Pre-assemble building fabricated from low maintenance, lightweight corrosive resistant aluminum (factory fabricated).
Building exterior shall have no exposed
fasteners.
1.
Dimensions
: 4' Width and 6' Length as stated above - with a 100'' nominal outside height. Interior dimension from floor to ceiling shall be 90" (2286
mm).
2.
Frame Construction
: Provide structural framing of 6063-T6 aluminum alloy extrusions.
Members shall have a Quaker Bronze finish. Connections shall be fastened internally to framing systems using mechanical fasteners or MIG welded where necessary. Exposed fasteners on framing system are not
acceptable.
3.
Base/Floor
:
.025 mill finish aluminum underside and a finished floor of aluminum anti-slip finished
floor for buildings
. Floor is mounted to a 4" angle steel base frame.
4.
Lower Wall Panel
: Exterior shall be .032 Quaker Bronze or White Anodized aluminum, 3" (76.2 mm) polyiso rigid board insulation (R-18) and .032 interior aluminum. Overall thickness of panel shall be 3" (76.2
mm).
5.
Roof/Ceiling Assembly
: Shall be constructed using
Hardboard- Factory coated
FRP
(fiberglass
reinforced
plastic/plywood
panel)
with
white
finish exterior and interior. Roof shall drain into full perimeter gutter
system.
6.
Windows
: Fixed windows shall be single pane 1/4" (6 mm) clear tempered safety glass. Sliding windows shall have aluminum frame and 1/4" (6 mm) clear tempered safety glass, insect screen, and locking
device. Glass shall be glazed within wall system extrusions and not fastened to exterior wall. Glass sealed with concealed gasket
system.
7.
Door
: Sliding door shall be extruded aluminum frame, top hung style using an overhead track and heavy duty ball bearing nylon tires with steel hub. Door shall be supplied with mortise hook bolt lockset with removable cylinder.
8.
Electrical
: Electrical shall be wired according to N.E.C. Standards. Load center
shall be a
100 Main amp, 120/240 volt unit with 8/16 open circuits.
Wiring shall
be
within
surface
mounted
EMT
conduit,
and
included
shall
be
(1)
GFI duplex receptacle with
tester.
9.
Lighting
: Lighting shall be a dual bulb fluorescent
light.
10.
Heat
: Heating shall be wall mounted electric with fan forced operation, 1500w/5120
BTU
thermostat
in
an
enamel
coated
20
GA
steel
cabinet.
11.
Counter
: Full width by 18" - 24" deep by
314"
white melamine work space counter with grommet hole
12.
Air Conditioner
: The Booth has a knock out panel for the air conditioner.
The air conditioner can be added for an additional cost.
Please contact us if you would like to have the air conditioner installed-guardboothonline.com.
Optional Add on Features: Contact us to discuss
Shipping will be calculated from Blackwood, NJ. 08012 A forklift will be required to off-load the Booth.